Transformador de iluminación RS PRO, 230V ac, 11.5V, 20 → 70W, Electrónico

Transformador Electrónico En Miniatura Atenuable Redondo De Salida Única

Transformador independiente IP20 para lámparas halógenas de 12 V.
Protección de clase II contra descargas eléctricas tras contacto directo e indirecto
El transformador se suministra con cables en los circuitos primario y secundario
Excelente fiabilidad de funcionamiento a temperaturas muy altas (ta = 45 °C; TC = 90 °C)
Tamaño compacto y pequeño
Montaje e instalación sencillos
Protegido contra sobrecalentamiento, cortocircuitos, picos de tensión y sobrecargas

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.